My New Box!! *PICS*

[saywhat? 5,000+ posts]

ps: get the **** on aim hoe!

 

[PV Audio 5,000+ posts]

Threadstarter, I meant no disrespect. If i somehow came off as mean, I apologize.

 

[PV Audio 5,000+ posts]

Grant, I'm on.

 

[Tirefryr 10+ year member]

Care to point me where I hated? Seems to me that he didn't take any offense at all. The thread starter didn't even make the box, it was his friend who got all angry about it.

Plenty of your posts THROUGHOUT the forum. . . You gained a little bit of knowledge and experience and immediately you're an expert. . .//content.invisioncic.com/y282845/emoticons/rolleyes.gif.c1fef805e9d1464d377451cd5bc18bfb.gif There's no need for you to say it outright, it's clearly conveyed in your type.

 

[PV Audio 5,000+ posts]

Umm, alright then...I guess you're right in assuming that's how I think. //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

But I'm not here to argue, so suit yourself. If you don't want to show me, then naturally nothing will change.

 

[saywhat? 5,000+ posts]

darwinism FTW

 

[saywhat? 5,000+ posts]

what did u use to match those pieces to be exact.

 

[saywhat? 5,000+ posts]

oh, shoulda went flush trim bit on a router. then again, its hard to control a router without a table.

 

[glowin3232 10+ year member]

i read the 1st couple of pages in this thread and all i have to say is that there are some ****ing morons on this site

 

[Chevillac 5,000+ posts]

i read the 1st couple of pages in this thread and all i have to say is that there are some ****ing morons on this site

//content.invisioncic.com/y282845/emoticons/eyebrow.gif.fe2c18d8720fe8c7eaed347b21ea05a5.gif :eyebrow:

Explain.

 

[saywhat? 5,000+ posts]

why? I then woulda had to cut one piece accuratly, then cut the other piece close to accurate, so I could use the flush bit... hmm.

no.....cut one how u want it, lay a square sheet over the design u want, corners lined up and just trace the edge. all it is, is a straight cut bit with a wheel. dont have to cut close at all, could go through a full sheet of MDF as long as u have a pattern for it to follow.

 

[glowin3232 10+ year member]

//content.invisioncic.com/y282845/emoticons/eyebrow.gif.fe2c18d8720fe8c7eaed347b21ea05a5.gif :eyebrow:
Explain.

dont feel like it

 

[Chevillac 5,000+ posts]

So,

Nevermind...

edit: //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 

[PV Audio 5,000+ posts]

dont feel like it

And thus, your opinion is worth less than the shit I just took.

 

[Chevillac 5,000+ posts]

And thus, your opinion is worth less than the shit I just took.

//content.invisioncic.com/y282845/emoticons/word.gif.64b12e39f936af3b4fff38a1c0bd0244.gif I pmed him cuz I didnt want to start shitting all over this thread again.