beginner
Member
Il try and keep it short so I get some answers.
Front components
rear coax
all 4ohmsx100
Rockford p450.4 60x4
I keep thinking I figured out the problem. This has been happening for a year, I replaced speaker wired, ground power, remote seems good, 3. Something ohms to each speaker and tweeter. Gains set with a dmm
It happens at high volume where there some kind of singing going on. Goes in protection mode for about 10 seconds comes back on and goes back unless I lower the volume.
One thing I noticed , replaced all speaker wires today and before I did that I could fade to each speaker and it would happen to all speakers except rl
After replacing the speaker wires i had my iPod on and it would only go in protection with the rr speaker and no other one. I took that speaker out and threw it on another channel and it went into protection, put that same channel back to original speaker and no protection so I figured the speaker was bad.
With the rr speaker disconnected I blasted my iPod for a while with no problems
Took a ride a few hours later and put a CD in and it started again even with that speaker disconnected. Im ******* annoyed with this. Someone please help. Sometimes people will ask something and never come back to respond. I need someone to help me diagnose please.
I tested all speakers and got 3.Something ohms , even tweeters. Could it be crossovers? Everything sounds good when working.
Thanks
Front components
rear coax
all 4ohmsx100
Rockford p450.4 60x4
I keep thinking I figured out the problem. This has been happening for a year, I replaced speaker wired, ground power, remote seems good, 3. Something ohms to each speaker and tweeter. Gains set with a dmm
It happens at high volume where there some kind of singing going on. Goes in protection mode for about 10 seconds comes back on and goes back unless I lower the volume.
One thing I noticed , replaced all speaker wires today and before I did that I could fade to each speaker and it would happen to all speakers except rl
After replacing the speaker wires i had my iPod on and it would only go in protection with the rr speaker and no other one. I took that speaker out and threw it on another channel and it went into protection, put that same channel back to original speaker and no protection so I figured the speaker was bad.
With the rr speaker disconnected I blasted my iPod for a while with no problems
Took a ride a few hours later and put a CD in and it started again even with that speaker disconnected. Im ******* annoyed with this. Someone please help. Sometimes people will ask something and never come back to respond. I need someone to help me diagnose please.
I tested all speakers and got 3.Something ohms , even tweeters. Could it be crossovers? Everything sounds good when working.
Thanks