MTX TA4501 Class D amp

  • 2
    Participant count
  • Participant list

p8ntballweird

Junior Member
7
0
803
Hey, I'm looking to power my 2 10' mtx thunder 6000's. I've looked around some, and found that this amp was only slightly more expensive than the TA3401 amps. My subs are 4 ohm, and SVC I believe... Not positive. Would this be a good amp to hook these 2 10's up? I'm really new to car audio and just want you guys's approval before I go buying an amp.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Thanks buddy! Given me a lot to think about in terms of what to do; I've been watching YouTube videos on this stuff all day as well so I really...
4
837
You can wire those subs up @8 ohms if they are both SVC4 ohm subs,and that amp will run fine after being tuned properly...
4
1K
The 240 should be 2x40/ 2ch. rated at 11.9v. Should generate close to 50+ @14v rms. Only Rated @4 ohms bridged Mono.. Should be around 125 rms...
5
2K
In 1990: The MTX MTA 225 had a MSRP of 549.95 25x2 0.02% THD S/N 102 12x 8 1/2x 2 3/8 The MTX MTA 250 had a MSRP of 649.95 50x2 0.02% THD S/N...
5
2K
Ok, i will go on this option. Thanks a lot bro for the help, i really appreciate again, Cheers
9
941

About this thread

p8ntballweird

Junior Member
Thread starter
p8ntballweird
Joined
Location
803
Start date
Participants
Who Replied
Replies
1
Views
713
Last reply date
Last reply from
CamryMTX
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top