Mmm.. Box inside.

oops, meant 36.

36 x 13 x 15

we were gonna make it 12 because it wouldn't fit, but slimming it from 40 clears the part that wouldn't fit.

So, plan adjusted a little //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 
Whoever said to brace it was right on - this baffle can barely support the weight of the woofers.
If this box doesn't hold up, I'll never use oak again. ****ed near $45 bucks a sheet after salestax.
//content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif//content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 
Box is built, and installed.

Burped it - lost a panel //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif

Just got back from home depot, had to buy some anglebrackets to reattach the board - Here's the pic

img3418ut7.jpg


 
Thank you for your support //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

I did have trouble on that panel, my cuts weren't perfect, and I didn't let the glue cure.

 
What 8's did you put in there? I'm building an 80inches designed 4th order for an L7 tomorrow... 80 must be makin some cheese from designs. //content.invisioncic.com/y282845/emoticons/greedy.gif.5a53e6246569d7ab79867170f3b06629.gif

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

theCybe

5,000+ posts
sector three
Thread starter
theCybe
Joined
Location
Columbus, OH
Start date
Participants
Who Replied
Replies
40
Views
2,251
Last reply date
Last reply from
Mitch86
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top