Can someone explain to me why this wouldn't work? I needed the speakers to be in series because they were originally wired in parallel from the factory, and after replacing them it would have been too much of a load (too low of impedance) on my amp.
-
1Participant count
-
Participant list
Can someone explain to me why this wouldn't work? I needed the speakers to be in series because they were originally wired in parallel from the factory, and after replacing them it would have been too much of a load (too low of impedance) on my amp.
Activity
No one is currently typing a reply...
Similar threads
The difference in 96 to 98 db is going to net you about an 22% difference in output, all things considered equal. When it comes to 325 per channel...
- Started by Mr FaceCaser
- General Car Audio
I'd say use 50-75% of recommended amount.
- Started by Original wis
- Speakers 2
gain set well below "Normal" and base boost is off completely
- Started by brice15s
- General Car Audio 2
Speaker to radio, rca from radio to amp for signal, amp to subwoofer
- Started by Jace14
- Wiring, Electrical & Installation
That was something I was going to try also to remove some of the gasjet from the front
- Started by Jimg
- General Car Audio
About this thread
