Loudest 12" SPL sub for 1600W RMS

1017019_10201244775194426_192225299_n.jpg
7.85 cu. ft kerf ported box, Hifonics BRX1600.1d amp, XS Power D680 battery.
 
bigger batts get a second amp and strap it on that beast! nice box
I'm already technically overpowering the sub, it's only rated for 1000W RMS but that is a very conservative rating. Would changing from a dual 4 ohm sub to dual 2 ohm sub make any difference? I love that box, had it custom built to fit perfectly in my trunk. Builder did an amazing job.

 
I'm already technically overpowering the sub, it's only rated for 1000W RMS but that is a very conservative rating. Would changing from a dual 4 ohm sub to dual 2 ohm sub make any difference? I love that box, had it custom built to fit perfectly in my trunk. Builder did an amazing job.
If you have a d4 woofer how are you over powering it ??

Lowest it wires is 2ohm and that amp isn't over 1k at 2 ohms

 
Currently I have an American Bass XFL 12" running on 1200W RMS at 2 ohms but my amp can do 1600W RMS at 1 ohm, and I'm always looking to get louder. What are your suggestions? I don't want to spend more than $500, cheaper is always best.

Thanks guys!
Sell the sub and the amp, use that money to get a 2k sub then with those $500 buy a 2k amp and another xs d680.

 
If you have a d4 woofer how are you over powering it ?? Lowest it wires is 2ohm and that amp isn't over 1k at 2 ohms
The amp is rated at 1200W RMS@2 ohms.

 

---------- Post added at 03:18 PM ---------- Previous post was at 03:17 PM ----------

 

Sell the sub and the amp, use that money to get a 2k sub then with those $500 buy a 2k amp and another xs d680.
I didn't want a full overhaul, just wanted to know if I could get louder with a different sub. Just bought the whole setup over the course of the summer.

 
You've got a mid level sub in a ported enclosure. Without a total overhaul your more or less at your limits, switching subs without switching boxes or upping power is going to be a very modest gain at best. If your looking to gain on a meter that could be possible, gain to your ears, doubt it, best case scenario you gain a little bass in one area and lose a similar amount somewhere else, which you may or may not find "louder".

 
Currently I have an American Bass XFL 12" running on 1200W RMS at 2 ohms but my amp can do 1600W RMS at 1 ohm, and I'm always looking to get louder. What are your suggestions? I don't want to spend more than $500, cheaper is always best.

Thanks guys!
Take a look at the Incriminator Dealth rows.

 
I'm already technically overpowering the sub, it's only rated for 1000W RMS but that is a very conservative rating. Would changing from a dual 4 ohm sub to dual 2 ohm sub make any difference? I love that box, had it custom built to fit perfectly in my trunk. Builder did an amazing job.
yea that sub will take more then the 1k easlily. i would get another amp and strap it. After box rise and voltage drop the sub will probly still be fine IMO. As of right now the amp is """rated"""" at 1200 rms @ 2ohm. after rise and voltage drop you probly seeing more like 600 watts RMS, especially since its daily for music so the power is going to flux. so my vote would be getting another amp and strapping it

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

jrdnhsnbrg

10+ year member
Pimped my grandma's ride
Thread starter
jrdnhsnbrg
Joined
Location
Eau Claire, WI
Start date
Participants
Who Replied
Replies
55
Views
4,975
Last reply date
Last reply from
bgowdy
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top