Loud single cab systems

[spencer321 10+ year member]

So to get it down to .75 ohms do i just parallel every 6 ohm voice coil together? Ill do it, i just need help with the wire. thanks

whats the coil config? im guessing dual 3ohm?

 

[phensway 10+ year member]

The subs are dual 6 ohm, so i have 8, six ohm coils. To get to .75 ohms i just parallel every coil correct?

 

[spencer321 10+ year member]

The subs are dual 6 ohm, so i have 8, six ohm coils. To get to .75 ohms i just parallel every coil correct?

yes

 

[viperrgh2 10+ year member]

I have my old system from my town car that I refuse to sell, was installed for a week then the car died. Anyways my new project is a 98' K2500 Chevy bought from the state, I'm currently rebuilding the motor but once thats done I plan on installing 2 MAW-15s with a Proifle Cali 2000W amp 480x2 rms. I plan on doing a blowthrough setup. I plan on building a heavy duty tool box like box to house the amps and sub box and then a rubber or something seal bolted to the cab and bed. I expect it's going to be very loud... will definatly post pics when I get around to it and some warm weather.

 

[spencer321 10+ year member]

I have my old system from my town car that I refuse to sell, was installed for a week then the car died. Anyways my new project is a 98' K2500 Chevy bought from the state, I'm currently rebuilding the motor but once thats done I plan on installing 2 MAW-15s with a Proifle Cali 2000W amp 480x2 rms. I plan on doing a blowthrough setup. I plan on building a heavy duty tool box like box to house the amps and sub box and then a rubber or something seal bolted to the cab and bed. I expect it's going to be very loud... will definatly post pics when I get around to it and some warm weather.

cool beans, since were bringing this thread back from the dead, i recently bought a hdc3 12 dual 2 planning on sticking it on a sundown 1500 in my standard cab, 2 cubes at 38hz, should be considerably louder than the rockford p1 15 on 200w lol

 

[JBGabriel 10+ year member]

Yea hdcs are great in trucks... Roll the windows down and it gets retarded.

 

[KHARPS 10+ year member]

Old thread but who cares.

 

[mbrooky 10+ year member]

regular cab ranger here...a little over 1cuft tuned to 30hz with two sundown e8s. subs/port firing up with port on passenger side. hit a 137.2 at the kick

 

[DB-Audio 10+ year member]

nice job on that system

 

[krainium 10+ year member]

Wow you must be short to fit your ranger with subs like that theres is no way I would fit in my ranger like that Im 6'

Looks loud!

 

[mbrooky 10+ year member]

Wow you must be short to fit your ranger with subs like that theres is no way I would fit in my ranger like that Im 6'
Looks loud!

lol.....just the passenger side is a bit cramped...box ends where the drivers seat starts...i can recline all the way back.

 

[Rusty...WCA 10+ year member]

only pic i have on it on my laptopbut did 157 at 2004 DB Drag WF

 

[cam5860 10+ year member]

The thing about a regular cab is you want to get it loud as possible, without giving up any leg room. The only way to do this is run 4 8's or two 10's. Both will sound **** good. A regular cab will only give you about 1.2 cubic feet without giving up leg room. Thats bottom depth 8 top depth 5 inches. Anything over that you giving up leg room.

 

[soundstreamer 10+ year member]

Here's my project... I started in the 130s. My goal is to be above mid 150s. Here is where I'm at so far:

Everything behind the seat on the truck

Vehicle: 1989 Chevy standard cab truck

Electrical System: Group 31 under the hood, nsb90 in back

Amplifier: RD Audio D9

Subwoofer(s): (2) RE SX12s (one with a scratching coil)

Box: 2 cu ft w/ 66 sq in of port (made for (2) 10" subs, retrofitted for the 12"s)

Song/Tone Played: 51 hz

The result:

There is nothing in the truck now. I'm starting all over again with the knowledge I've gained so far. As a matter of fact I have some new subs that just got to my house while I was typing this at work My new amp shouldn't be too far behind //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[Lakota 5,000+ posts]

Where was the meter?