Kicker 350.4 and Components

[rezurxtion]

Here is the problem. Dodge 2003 Ram Quad Cab with Sony Head Unit. I am running Kicker 3Way 6X9s and Kicker component tweeters in the front. The back is being filled with Kicker 6 1/2s. How do I wire these within the Amps 2/4 Ohm capability? Do I wire the each 6X9 and Tweeter in parallel in the front = a 4 ohm load or what? I just do not want to overload the amp. Thanks.

Click to read more...

 

[Montypup 10+ year member]

Use the crossover supplied with the components, and then just tie the fronts and rears together, that way you'll end up with a 2 ohm load.

 

[m48xhp 10+ year member]

Use the crossover supplied with the components, and then just tie the fronts and rears together, that way you'll end up with a 2 ohm load.

why would you do this? if you tied the front and back together you would get a 2ohm load, but then split between the speakers. whcih will end up with a lower output then just wiring them in 4 ohm. then you will loose the front-back fade function.

i say use the crossovers, then wire one crossover to each channel at a four ohm load.

 

[BaseSteala112 10+ year member]

You could use your amp to power your components and 6x9's. Then just run your rear doors off of you HU for rear-fill. Theres different possibilites.