Kicker 10" L7

  • 2
    Participant count
  • Participant list

drow555

Junior Member
8
0
Flint
im thinking about buying a 10" kicker L7 dual 2 ohm sub from a friend. i know that if i wire it in series, i need an amp that could power it while running at 4 ohms. i have a profile HA1000 that puts out 480rms bridged at 4 ohms. the sub handles 600rms, so this should be a good setup, right? its going to go in a sealed box with ~1.5 cu. ft.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Yep, that will mark the third iteration of teh X series. i figured that was in the loop as they have been running out of stock on the last...
11
524
Is this a blue or blue/white wire from the Kenwood? The ACC wire is red and although that should turn on the amp, it is not the prefered wiring...
1
733
low level when using RCAs so that knob should be pushed out. The crossover turn it all the way right and use the one on the head unit and set it...
5
1K
Not all 3 have same issue. Was just giving an example of the issues Each one has its own issue Yes I did replace rca cables and swapped left and...
3
1K

About this thread

drow555

Junior Member
Thread starter
drow555
Joined
Location
Flint
Start date
Participants
Who Replied
Replies
2
Views
412
Last reply date
Last reply from
drow555
IMG_5880.jpeg

Brendon Jenness

    May 11, 2024
  • 0
  • 0
IMG_3567.jpg

RedRyder18

    May 11, 2024
  • 0
  • 0

New threads

Top