keep Poping amps...help

[gotflex]

hi all .. right stay with me on this .iv just blown my 3rd amp another one dead ..

1st one vibe 1200w 2 ch

2nd one legacy 2000w 2 ch

3rd legacy 600w 2 ch works but only at half vol ????

system ..in the cab eonon touch 7" hd head unit 1xsub, 1front l+r and rear l+r rca outputs

2 x 5" fusion mids crossovers tweeters 250w

2x 8" mid bass units 200w

running on amps

gto 400w 2 ch amp running 4 6x9s running 2 in series (switched on by rem)

sony explod 1600w 2 ch 2x maystar subs 250w on a

3 mutant mt1207 800w 12" subs in custom enclosure tuned to 33hz

the 3xmutants and the amp running these is the problem .. subs show ..3.8 ohm indavidualy

i had all the positives running back to the amp . and all the negatives from subs to amp (the vibe/bridged) worked fine for a few weeks then it just didnt switch on one day

second amp legacy . was told to run them in series amp+ - + - + - amp which again worked for a few days this time and the amp just fizzled and poped when i was showing off . utter fail

and these sony amps im just confused about . i was told u cant bridge them so again a ran subs in series back to one channel on the amp and it barly moves the sub again aft a day or so it just packed in ...

i do have a split charge system in the van which i have ruled out.

i also have 3 batts in total . 1 under the bonnet 2 in the rear strapped both 590ma leisure battery's deep cycle which charge via . solar panel and split charge system

any help would be awesome in solving my issues if ya unsure just ask . ill post any picks kneaded if it helps . i love my system and me van help me fix it plz ..

Click to read more...

 

[goingdef 10+ year member]

It sounds like your running cheap amps at around 1ohm so yea they aren't going to last long also I'm pretty sure those are all ab class amps.

 

[gotflex]

right so how do i wire these 3 subs then and what am i looking at £££ for amp to run them properly ... thought the vibe 1200w was class d so was the legacy

 

[goingdef 10+ year member]

right so how do i wire these 3 subs then and what am i looking at £££ for amp to run them properly ... thought the vibe 1200w was class d so was the legacy

I don't know what class they are but I do know there cheap! So get a decent amp that does rated at one ohm and wire it the way you have it now there's not much else you can do with that vc config.

 

[gotflex]

i am planning on replacing these subs like! at some point im on a budget atm

i do have 2 jbl500w dual vc subs i was thinking of just putting them in that box and just sealing it till i can afforded to buy a decent amp .. wht do u think legacy amp is 2 ohm? .

and what is a decent 2000w amp these days it was 10 year ago last time i had a car with proper audio (alpine full system)

 

[gumby688 10+ year member]

New Audiopipe APSM2000 Mini Design Class D 2000W Amplifier Amp 2000 Watt | eBay

Audiopipe 2k can be had for less than 200 bucks shipped not sure what it would cost to get sent international.

Used 3Kings before had a shipping issue Ryan fixed it on the spot had nothing but top notch customer service from them

 

[quackhead 10+ year member]

i am planning on replacing these subs like! at some point im on a budget atm
i do have 2 jbl500w dual vc subs i was thinking of just putting them in that box and just sealing it till i can afforded to buy a decent amp .. wht do u think legacy amp is 2 ohm? .

and what is a decent 2000w amp these days it was 10 year ago last time i had a car with proper audio (alpine full system)

B² audio - Sweet like Danish

 

[quackhead 10+ year member]

I would suggest you wire a digital voltage meter like this:

Xscorpion DVM23BB 3-Digit LED Digital Voltage Display VoltMeter

or whatever you can find and have it linked to the power wire near or at the amp to make sure you do not pull the batt voltage too low...this will fry amps too.

YOU NEED A CLASS D 1OHM STABLE MONOBLOCK.

 

[gotflex]

bat at amp runs a steady 13.6v iv got a meeter just not sure how to set it prop lol ..il take picks tomorrow its 0118 now im uk btw

 

[slammedincouch 10+ year member]

 

[d77543020 10+ year member]

yea all those amps you were running are 2 channel amps get a bass amp