JL Audio Cleansweep question

[Kaos 10+ year member]

I'm using a JL Audio Cleansweep to add a JL 300/4 and JL 500/1 to my factory H/U. My question is how do I feed the JL 500/1? I am using the front and rear RCA outputs on the Cleansweep to run the front and rear channels on the JL 300/4. Can I just use a set of RCA "Y" off the rear set of RCA outputs on the Cleansweep to feed both the rear speaker channel of the 300/4 and to feed the sub from the 500/1? Will this work? Will I have any negative effects? What will happen to the 8v output of the Cleansweep when split like this? TIA.

Click to read more...

 

[BassMechkanic 10+ year member]

yes that will work, or does that amp have a output rcas? if so use that to the 500.1

 

[1hawaii50 10+ year member]

Give JL a call. They have a free tech line and are very knowledgeable and helpful.

 

[anj46907 10+ year member]

da ****

 

[WrenchGuy 10+ year member]

If you can just use the outs as stated.

The input voltage will make the output voltage just as strong and clean.