Sold JBL Crown amps CHEAP

Street DreamsCC
10+ year member

CarAudio.com Elite
Rating: 0%
0 0 0
I have 2 JBL Crown 6000GTi amps that do not have the outter case from my SPL van. These are by far some of the best sounding and cleanest sounding amps I have ever had the pleasure of playing with. These are well worth every penny.

VERY RARE you cant find alot of these anywhere. You can be one of a kind in your area. Excellent amp for street classes and even daily.

from JBLs website these ratings are RMS

Output Power at 14.4V and ≤1% THD+N (CEA-2006):

2 x 2600W @ 4 ohms

1 x 8110W @ 4 ohms

1 x 7400W @ 1 ohm

S/N Ratio: 65dBA (1 Watt, 4 ohms)

Effective Damping Factor: 6.39 @ 4 ohms

Freq. Response: 10Hz ∼ 270Hz (-3dB)

Fuse: 600A internal (external 500A minimum)

Dimensions: 29.38" x 23" x 6.5" (74.6cm x 58.4cm x 16.5cm)

Weight: 88 lb. (40 kg.)

This mono amplifier has +/-165 Volt DC rails that power two 3 KW BCA (balanced current amplifier) half-bridges.

This allows three modes of operation:

1. Two high-voltage amps each driving 2-4 ohms with 160V+ peaks.

2. A single bridged output driving 2-4 ohms with 320V+ peaks.

3. A single paralleled output driving 1-2 Ohms with 160V+ peaks (patented).

http://www.jbl.com/car/products/prod...at=AMP&ser=GTI

http://ampguts.realmofexcursion.com/JBL_A6000GTi/

6000-Watt Balanced-Current Subwoofer Amplifier With Current Servos.

Built-in variable electronic crossover with selectable slope rate.

Dynamic Bass Optimization (DBO) - This provides variable filtering with adjustable "Q" below 100Hz, far beyond conventional "Bass Q" circuits, by allowing the low-frequency output to be optimized for specific subwoofer applications. Frequencies below an enclosure's tuning frequency can be attenuated, preventing damage to the subwoofer and allowing the amplifier's power to be better utilized.

Variable phase control

Full-range preamp outputs - In the event that multiple amplifiers are used in an application, this feature allows for streamlined system hookup. No high-loss Y-adapters or splitters needed.

$1500ea plus shipping and crates

($2000ea with the case, Dealer cost was $5000ea, usually sold for @$2500ea)

Pickup is always welcomed. All have been tested and were just used and pulled a 161.3dbs certified on a termlab on a 14v system.

Pictures are aval. upon request and only serious people please.

Thank you

--------------------------------------------------------------------------------

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Street DreamsCC

10+ year member
CarAudio.com Elite
Thread starter
Street DreamsCC
Joined
Location
NEW YORK
Start date
Participants
Who Replied
Replies
1
Views
489
Last reply date
Last reply from
Street DreamsCC
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top