Is this how you wire a sub?

[PWNED 10+ year member]

I have a FI Q Dual 2.So does that mean its a 2ohm dvc?And has to be wired like this.I got the image off of the12volt.com

http://www.the12volt.com/caraudio/woofer_configurations.asp

Click to read more...

 

[tapout 5,000+ posts]

yes

 

[PWNED 10+ year member]

Also my amp has 2 sets of inputs.Does it matter which set of inputs the wires go into?You can see in the picture

http://www.sonicelectronix.com/item_5647_MTX+Audio+TA81001+Thunder+81001.html

 

[Immacomputer 10+ year member]

No, it doesn't matter which set you use; they're there for convenience if you have multiple drivers.

 

[JLJunkieMX107 10+ year member]

Also my amp has 2 sets of inputs.Does it matter which set of inputs the wires go into?You can see in the picturehttp://www.sonicelectronix.com/item_5647_MTX+Audio+TA81001+Thunder+81001.html

I only see one set of inputs on that amp?

 

[PWNED 10+ year member]

I only see one set of inputs on that amp?

On the left side of the amp there are 4 places for wire.2 pos and 2 neg.Unless i am not speaking correctly.

thanks you answered my question iimmacomputer

 

[blakegeee 10+ year member]

2 outputs i think, aka 2 channels...

 

[jkulysses 10+ year member]

2 outputs i think, aka 2 channels...

Please tell me your kidding. Both my MTX mono amps have two sets of inputs. From what I've read if you have say two dual 4 ohm drivers you can wire them down to 2 ohm and then hook one up to one set of input's on the amp and the other one up to other input and then the amp will see a 1 ohm load because how how those 2 sets of inputs are wired inside the amp. I'm still half asleep so this probably makes no sense at all but I tried.

 

[ultimate157 5,000+ posts]

Yup, the terminals are wired in parallel inside. Only reason there is two is for convenience.

 

[04_edge 10+ year member]

2 outputs i think, aka 2 channels...

lol

 

[PWNED 10+ year member]

Thats interesting..Ok so my situation it does not matter what set i use then

 

[jkulysses 10+ year member]

Thats interesting..Ok so my situation it does not matter what set i use then

I have my positive going to one side and negative to the other side and it works fine, so no it don't matter which ones you put them on, as long as + is on + and - is on - lol.

 

[Atimm693 10+ year member]

Please tell me your kidding. Both my MTX mono amps have two sets of inputs. From what I've read if you have say two dual 4 ohm drivers you can wire them down to 2 ohm and then hook one up to one set of input's on the amp and the other one up to other input and then the amp will see a 1 ohm load because how how those 2 sets of inputs are wired inside the amp. I'm still half asleep so this probably makes no sense at all but I tried.

Stop calling them inputs, theyre outputs.

 

[jkulysses 10+ year member]

Stop calling them inputs, theyre outputs.

Like I said, I was half asleep lol. I literally wrote that 5 min. after I woke up before I got ready for work.