rumblefish
10+ year member
Member
I finally finished my install in my Tahoe. Yesterday I was setting the subsonic filter and the output reduced to almost nothing. This was at a very low volume. I adjusted the gain a little and everything seemed ok. Driving around yesterday I noticed that the subs would randomly get quiet. When I got home I put in test tone and grabbed the multimeter. Sure enough, for some reason the maximum amount of voltage I could get was around 42 volts. Then it would jump back up to over 100. This was the gain all the way up just to see what it was doing and no load obviously. So that ruled out the subs. I also took the rca's going to my front stage amp and tested it. Same result. And that was from the front outputs from the deck(with the crossover off to make sure I had a full signal). So that should have checked both the cable and the output from the deck. All power/ground wires seem secure. I have never had a problem with the amp until I adjusted the subsonic filter. Is it f**d?
