Installed new comps, now getting noise

Owners1
10+ year member

Senior VIP Member
Recently just installed new front speakers into my system.

My stereo now plays a whining noise which does not seem to be engine induced. Before installing speakers everything was fine no noise.

Here are my symptoms:

Tested a speaker on the headunit with speaker wire outputs = GOOD

Ran new remote wire and still noise

Ran new RCA wire to back and still noise

On my new component speakers one of the capacitors blew very badly where it was smoking out of one of the new speakers

Rear speakers which weren't touched with are now making noise as well

The comps in the front are 2 ohms. The ones in the back are 4 ohm. possible amp problem from mixing ohm loads?

Also,

after attempting to play it with the noise, one of the crossovers exploded. a cotton like material exploded everywhere from outside the crossover.

Wondering what you guys think this could be and what would be a way to test the output and input problems on my headunit/main speakers amp.

Thanks

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Owners1

10+ year member
Senior VIP Member
Thread starter
Owners1
Joined
Location
Palm Beach Gardens, FL
Start date
Participants
Who Replied
Replies
2
Views
469
Last reply date
Last reply from
Owners1
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top