Hi, I just purchased a travel trailer with a cassette deck from the 80s. I went and bought a Pioneer DEH-S4220BT and proceeded to try and install it. I wired it up the way I thought it should be, but it wouldn't turn on even after pressing the microprocessor reset. Then I discovered that there was 17.4 volts across the power and ground.
I had both the yellow and red attached to power.
Disconnected there's 13.3 volts, red only 13.3 volts... yellow only 17.4 volts and all the lights in the trailer are brighter.
I'm obviously not doing this properly. Any help would be very much appreciated. Thanks in advance,
Scott
I had both the yellow and red attached to power.
Disconnected there's 13.3 volts, red only 13.3 volts... yellow only 17.4 volts and all the lights in the trailer are brighter.
I'm obviously not doing this properly. Any help would be very much appreciated. Thanks in advance,
Scott