I am having an issue with my inline main fuse. I have had the same setup for probably 6 years in my truck and after I sold it I moved to my car. I purchased an lc2i and hooked up to my factory head unit. This has been working for over a year with a 10 in sub. I just purchased a 12 in sub and evertime I switch the speaker wite to the 12 it blows in 10 to 20 seconds. If I hooked the 10 back up and put a new fuse its fine. Any suggestions.
-
2Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
Should be good to go without those fuses. Read the manual that comes with the new stereo. If it doesn’t say to add additional fuses, don’t.
- Started by Kyrk
- Wiring, Electrical & Installation
It was a powered 12 inch subwoofer. I don’t remember the exact one. It has been a while.
- Started by Paul Curtis
- Wiring, Electrical & Installation
It would be cheaper, it might be easier to find a place to mount it, and you would have a ton of options if you just do two, 3 slot fuse holders...
- Started by .........
- Wiring, Electrical & Installation
About this thread
New threads
-
-
-
-
-
Fuse Taps at 30amp with 16AWG....
- Started by Paul Curtis
- Replies: 11