Infinity Speakers

[Fender5 10+ year member]

Since they have a 2 ohm impedence, it is throwing me off.

The amp I am getting is the Kenwood excelon x40. It puts out 100W RMS @2 ohms and only 70W RMS @ 4 ohms

The front speakers are 90W RMS and rear are 100W RMS

I can't wire these speakers up at 2 ohms can I? It just doesn't seem possible. Only 1 ohm and 4 ohm right?

The excelon is a 4 channel amp.

What do I do.

Click to read more...

 

[Curel 10+ year member]

Just don't bridge the amp and you will be fine. Hook it up like you would a normal speaker.

The speaker is 2 ohms. This will present a 2 ohm load to the channel it is hooked up to thus yielding 100 watts RMS. You do not need to do anything different from a normal installation.

 

[redcalimp5 10+ year member]

Good question, and good, to-the-point answer, fellas. I've always kinda wondered about that, too, actually.