i made my new box

[andytb 10+ year member]

well today i made a box for my re se 15 that should be here some time this week

3.5 cubic feet 25W x 15.5H x 24L 3.5 inch port tunede to a little over 34 according to the re calculator

Click to read more...

 

[IgnoreMe 5,000+ posts]

i think your going to need to use some seriously silicon to get that top piece to sit flush lol

 

[Worlddre 5,000+ posts]

um ok

 

[andytb 10+ year member]

its not screwed in yet

 

[andytb 10+ year member]

im gonna finish it when i get the sub

 

[Qbenjamin 10+ year member]

Um, take that out and re-screw the lid. You are going to have some major leaks from what I can see. Silicone II is a must in your situation.

 

[andytb 10+ year member]

i didnt put the top on because i knew it would fit in the car i had to sand down a spot where the seatbelt goes because it was to high

 

[NhustlaR 10+ year member]

//content.invisioncic.com/y282845/emoticons/woot.gif.aaa6090e619a97b6090d16dd863c5a69.gif i was in sandusky last weekend. fun times

 

[ravendarat 10+ year member]

what tool did you use to cut the wood, A jig saw maybe?

 

[andytb 10+ year member]

i used a POS delta table saw at first then i said F it and used and craftsman circular saw

 

[andytb 10+ year member]

what brought you here

 

[ravendarat 10+ year member]

i used a POS delta table saw at first then i said F it and used and craftsman circular saw

The reason I asked is because your port looks like it has a ripple in the edge and that could cause some nasty port noise if not taken care of

 

[andytb 10+ year member]

im gonna sand everything the best that. i can im not the greatest at cutting wood

 

[jmanpc 5,000+ posts]

good luck with it?

 

[andytb 10+ year member]

im not looking to set records or anything well obviously not with that setup