how would i wire....

[badnewz122]

How would I wire 2 DVC 4ohm subwoofers in parallel to a mono amp with 2 terminals?

Click to read more...

 

[soloXgt 10+ year member]

what amp

 

[tRidiot 10+ year member]

You don't need to use both sets of terminals if you don't want to.

If it's a mono amp, they're just connected internally. You could wire your VCs in parallel with each other (for 2 ohms per sub) and then one sub to each set of terminals, would be the same as running the subs in parallel, a 1-ohm final load.

 

[badnewz122]

so basically if i wire it in parallel to one terminal or two it doesnt change the impedance load. because i want the final load to be 1 ohm on the sub to get the most out of it.

 

[ThatChevyGuy 5,000+ posts]

Yeah if its a mono.

What amp?

 

[badnewz122]

i'm not sure i havent purchased one yet, i just wasnt sure how the mono amp had two terminals? that kinda confused me. But i guess if they are internally wired in parallel it wont affect the outcome. but i am looking for a pair of subs with an RMS from 800-1000W rms and a solid amp to match it with a total 1 ohm load

 

[tRidiot 10+ year member]

800-1000 per sub? So 2k total? Or for both?

 

[badnewz122]

per sub, which is alot i know, but i am looking for good subs and a good amp to match it. so wat should i look for in the amp? the rms for the mono amp needs to be about 800W RMS 1 ohmX 1 channel correct?

wat mono amp would u suggest for a set of DVC 4 ohm subwoofers with around 800W RMS