Mr. Mega Cab
Junior Member
looking to remove the factory sub from compartment behind back seat and add an aftermarket amp and subs. curious if I can use the factory sub speaker wires with a line out converter to get signal via rca. can anyone help?
how to wire up line out converter in ram 3500 w/ factory alpine stereo
- Thread starter Mr. Mega Cab
- Start date
- Replies 3
- Views 700
-
3Participant count
-
Participant list
LosIsATool 5,000+ posts
CarAudio.com Veteran
Look at the Audiocontrol LC-2i. Don't go cheaper.
AFS585
Member
this. every time i sell a LOC i push this unit hard and am largely successful. it breaks my heart when they cheap out and choose the PAC LP3.
- Thread Starter
- #4
Sweet. Thx guys.
Activity
No one is currently typing a reply...
Similar threads
Use this for the PB bypass.
- Started by HandsomeSteve
- General Car Audio
Sweet!!!!!
- Started by ikpthegame
- Wiring, Electrical & Installation 2
Drill a hole and use the proper protective split loom and hole grommets to keep the outer speaker jacket from knicks and cuts, give just enough...
- Started by Red Dog
- Wiring, Electrical & Installation
It mostly comes down to weight. You can have a super lightweight cone, soft suspension and aluminum coil on a sub and you pretty much get a pro...
- Started by MrButtersworth
- Subwoofers
Yes . Until i get a 3.5 or 4 inch mid
- Started by Bass so loud it HZ
- General Car Audio
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 3
- Views
- 700
- Last reply date
- Last reply from
- Mr. Mega Cab
Latest topics
-
-
-
-
Jeep center console sub install issues.
- Started by vlusardi
- Replies: 1
-
