How to mount my amp?

[GreenLantern747 10+ year member]

hey guys, hope this is in the right forum. anyways, i'm trying to find a way to mount my amp, and i can't figure out how i'm gonna do it. right now its mounted to the back of my seat, as it was done on install night (at 2 am) and has since been there. I'm not building me a new box, and i'm gonna need to move the amp. its going in an 02 zx3 focus. the box i'm thinking of going with is either going to be sealed or ported, but flush against the back of the rear seat, and as tall as it can be made. the amps an audiobahn A1300HCT

and i'd kinda like to show if off a little since its chrome and all. was gonna try and do a false floor, but after reading the manual, it suggests not to cover the top of the amp for and inch. and don't know how that would look in the floor. guess i could go that way, but just wonderin if anyone had any other suggestions. any help greatly appreciated.

GL

Click to read more...

 

[drkodin 10+ year member]

you might want to try something as simple as i did for my old car. i had the subs flush against the back seats with a piece of wood in front that had the amps mounted to it.

http://www.sounddomain.com/memberpage/352493

if you cut the wood for a perfect fit and run the wires under the floor it look real nice and simple when done. if you want a more custom look, raise the amps with washers/spacers off the wood about 1/4" and then cut a hole (smaller than the amp) into the wood under the amp. mount a neon light under the piece of wood and a glow comes out all around the amp and you can never see the bulb.

 

[GreenLantern747 10+ year member]

wow, thats a pretty clean setup. only thing is i'm trying to keep some trunk room. don't need a whole lot, but still need some.

GL