How to hook up a Electronic Crossover? Need HELP ASAP

[nofriends46 10+ year member]

I have a profile elctronic crossover.

Can you hook up a power wire to your distribution

block or you have to run another power wire from the

battery, 16-18guage?

Also the remote, the remote comes from your head unit.

So you only need one remote right, the signal turn on

lead will go to the amps (you wont need a remote wire

to your amps, right or no), or you have to run a

remote to your amps to? Pretty confusing!

Any other suggestions, i'm gonna install 2 amps, one

for sub and 1 for high pass.

What should i set the sub setting and the high pass

setting? My head unit has a crossover, subwoofer

outputs, i just leave the electoronic crossover flat.

ps. if you know a webpage that has a picture, every step, more easier to understand, that would be great

Would it make a different if i install a eletronic

crossover? Thanks!

Click to read more...

 

[beastyle 10+ year member]

Depends on the cable you have, if you have something near 20 kwadrant then you can just put it on your distribution block and take an end cable from there.

All your amps require a remote, so just put the remote from your HU on a distribution block and connects from there to your amps

HU sets are personal however I also have HP/LP on my HU which I dont use... I have two amps for HP with the only difference in frequenty (more high @ front speakers and "more" low on the rear speakers)...

gl

 

[nofriends46 10+ year member]

what amp fuse would you suggest for the remote?