How do I tune both my Amp and my Line Out Converter?

  • 1
    Participant count
  • Participant list

magman

CarAudio.com Newbie
2
0
I am confused on how you tune an amp and line out converter at the same time. I have an LP7-2 LOC, and R1100M Amp and they both have gain knobs on it. I understand that for each, if tuning by ear, you need to put your radio at 3/4ths volume, play a 40hz test tone, and then turn the gain knobs up until the subwoofer starts audibly distorting, but how do you do it both? The only thing I can think of is to just leave the LOC at 100% gain and then turn the amp up until it starts to distort and then leave it right before it distorts, but is that really the right way?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Speaker ratings are generally a thermal/mechanical limitation of the drivers. Music is dynamic, not continuous. During quiet periods a song, you...
4
608
The correct answer is yes, you want both left and right so you get low end information from both channels. It is very common for recording...
2
2K
Is that a car show? Wow. Too much ground loops. The magnetic field may interfere with frequencies going to the antenna. Or you just need a...
15
2K

About this thread

magman

CarAudio.com Newbie
Thread starter
magman
Joined
Location
Start date
Participants
Who Replied
Replies
0
Views
2,339
Last reply date
Last reply from
magman
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0
Screenshot 2024-05-31 182324.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top