Austinw88
Senior VIP Member
I know this get's asked a lot and I did a little searching and came up with no answer to my problems, I get everything put in like I think it should. But when i do the port everyone useually recommends 16sq inches of port, I never come close to it. If I do come close to it by changing things it throws my tuning waaay out into the mid low 20s. heres what I have.
Outer Dimensions
height: 16"
Width: 40"
depth: 20"
port dimensions
Height: 14.5"
Width: 4"
Length: 26"
what I come up with is
4.33 sq ft
13.39 sq in of port per cube total of 58.00sq inches
Tuning frequency is 33.43??
I'm looking to get 4Sq ft net volume tuned to 32hz with 16 sq inches per cube, what am I doing wrong?
Outer Dimensions
height: 16"
Width: 40"
depth: 20"
port dimensions
Height: 14.5"
Width: 4"
Length: 26"
what I come up with is
4.33 sq ft
13.39 sq in of port per cube total of 58.00sq inches
Tuning frequency is 33.43??
I'm looking to get 4Sq ft net volume tuned to 32hz with 16 sq inches per cube, what am I doing wrong?