help! no audible output, can barely feel sub vibrating

eWRXshun
10+ year member

Junior Member
i just hooked up my e12k.44 dual 4 to my alpine mrd-m500 amp.

i wired it correctly i think

from + on amp i split it to 2 wires, one to each pos. terminal on voice coils.

from - on amp i split it to 2 wires, one to each neg. terminal on voice coils.

isnt this a parallel configuration? shouldnt this drop the load to 2ohms and make the power output 500watts? why am i not getting any sound and so little vibration?

also, wiring from amp to sub is 16ga, might this have anything to do w/ it?

 
thanks anyway, i found out the problem. one voice coil's teminals was labeled wrong, even though it matched up the picture on the website. works fine now. thanks.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

eWRXshun

10+ year member
Junior Member
Thread starter
eWRXshun
Joined
Location
New Orleans
Start date
Participants
Who Replied
Replies
2
Views
557
Last reply date
Last reply from
eWRXshun
IMG_1882.jpeg

slater

    Oct 4, 2025
  • 0
  • 0
Screenshot_20251004_120904_Photo Translator.jpg

1aespinoza

    Oct 4, 2025
  • 0
  • 0

New threads

Top