Sold FS: Amps Kenwood KAC-729s and Power Acoustik PA2-1200

Pitchblack98
10+ year member

Senior VIP Member
Rating: 0%
0 0 0
I have (2) 2 channel amps I was going to use. I just dont have the room to install them in my truck. One is a Kenwood KAC-729s and the other is a Power Acoustik PA2-1200. Im selling these to get some money to buy a 4 channel amp. I will also trade one or both of these amps for a 4 channel amp. I can even throw in cash on a trade if I need to.

Here are the specs...

PA2-1200

Full Mosfet PWM Power Supply

Full Selectable Crossover Hi/Full/Low

Three Way Protection Circuit

2ohm Stable Stereo

Tri-Mode Capable

System Distress Indicator

High/Low Level inputs With Floating Ground

4 Gauge Power/Ground Connection

Gold plated RCA Connectors

250x2 @ 4 ohm rms

300x2 @ 2 ohm rms

600x1 @ 2ohm rms

1200 peak bridged

20.5” x 11.25” x 2.25”

KAC-729s

2-Ohm Stable

Power Indicator

Screw-Type Power and Speaker Terminals

Speaker Relay Protection

Amplifier Type: 2-channel

RMS Power @ 4 Ohms: 100W x 2 @ 14.4V

THD at 4-Ohm RMS Power: 0.08%

Bridged RMS Power @ 4 Ohms: 300W x 1 @ 14.4V

Speaker Level Inputs: yes

Preamp Outputs: no

Built-In Crossovers: HP/LP

Bass Boost: 0

Frequency Response: 20-20,000 Hz

Signal to Noise Ratio: 100 dB

Fuse Rating: 2x20 amps

Kenwood... $90 shipped obo.

Power Acoustic... $75 shipped obo.

I can get some pics up later tonight.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Pitchblack98

10+ year member
Senior VIP Member
Thread starter
Pitchblack98
Joined
Location
Littleton, CO
Start date
Participants
Who Replied
Replies
0
Views
912
Last reply date
Last reply from
Pitchblack98
IMG_20260506_140749.jpg

74eldiablo

    May 22, 2026
  • 0
  • 0
design.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0

New threads

Top