?? for those who only have front speakers

[cazorp 10+ year member]

Do you actually take your rear speakers out or do you just adjust the fade to all front???

I am thinking of a nice set of components and was going to do front and back but thought i may like just front speakers better.

so since i have stock 6x8's in the back should i unhook them or just adjust the fade on my headunit??

thanks

zach

Click to read more...

 

[sandbags 10+ year member]

in my car i took them out, in my suv i just disconnected them

 

[jjski78 10+ year member]

I left my stock rears in, powered off the HU, and set the fader mostly to the front.

 

[alteraudiousa 10+ year member]

took them out of the rear deck of my Galant. I may add something back there later just to show people a rear fill done right is good, though.

 

[DejaWiz 5,000+ posts]

Disconnected mine.

 

[jmanpc 5,000+ posts]

My van has factory amps, so I didn't even hook up them up.

 

[Andrew Capps 10+ year member]

I took mine out of my jeep completely

 

[2wheeler 10+ year member]

Mine are still there, but only until I find some cheap speakers to fill the holes. I'm using a 50x4 amp that I bridged to 100x2 to the front comps. Best no $ improvement ever.

 

[headless 10+ year member]

Left mine in, just clipped them. I can't figure out how to get the ****in rear deck off without damaging it...i'd prefer to rip em out and leave the grilles on so there would be holes there through to the trunk - might not have to have my rear seats down to keep the rear deck from rattling so much when the sub hits if there was good ventilation in the rear deck.

 

[tez4life Premium Member]

Took mine out to allow some of the pressure from my subs from rattling my trunk so much. Def increased the output of bass inside my car.

 

[JimJ 5,000+ posts]

Never had any to begin with...

 

[phyphoestilic 5,000+ posts]

mine were just disconnected when i took out my stock amp