First post , quick Q about glassing a brand new car...

[sth_sd_cstmz]

Hello all , and thank 'ee for welcoming me to the site (in advance).

Ok , heres my skinny...

Current Whips :

Mine : 86 honda accord dx (in progress/under destruction)

Lady's : 03 pontiac sunfire (i know.... but its not that bad.... //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif )

Im looking to put a newly acquired (via ebay) bazooka csw1004 10" sub in the rear

love handle. (that fat spot in the trunk behind the wheel well and gas - fill - pipe). Im still searching for the right amp , a 402.5 kicker or similar. An ex roomate has a kicker 402.5 on 2 PBX 12"s and it bangs harder than a horny gorilla. I would like to fiberglass the 10 into that spot , but im not too sure if it would be better to fg over the existing carpet (somewhat molded to fit , but it still has a 1" gap to the metal) , or cut out a section of carpet and make my own form out of tape against the metal.. She's iffy about the whole situation as it voids most of her warranty... so i have ot be sure that with minimal repair (ie throwing a piece of carpet in) that this could be easily removed and no irreprable damage to the car is done %2voids most of her warranty... so i have ot be sure that with minimal repair (ie throwing a piece of carpet in) that this could be easily removed and no irreprable damage to the car is done (at least not anything noticeable).

Now onto my ride ,

i have an 86 accord P.O.S. that is still under destruction. I have pulled out hte back seats , in leu of oneday actually putting some decent money into the car , and it could be a nice little ride (via some crx body and some new fenders.... it really needs new fenders....).

Hopefully i can find a nicer one for a little bit more money , and i can put all my shtuff from this into the nice one , and do the work to it and make it show quality.

anywho , my planned setup in the accord is 2 PBX 15"s (1200w rms 1600 peak) , and whatever amp i have layin around to handle the power... along with remote dual batteries (or more if i need em) , dual alternators (15v), and entire rear seat/trunk area fiberglassed to hold both sus right behind the seats , and the amps on top with some built-in ccfl lights , then have the batteries in the back , with thier own little pod , and maybe even a fuel cell with its own little pod.

btw : did i mention all of that is modular and can be removed with a single 1/2" wrench.... lol.....

thanks all for reading....

-jay z

southside customz

youngstown ohio

Click to read more...

 

[saywhat? 5,000+ posts]

soooooo u have a custom shop? and your doing this there? and how the hell does glassing void warranty, the only things that void warranty, is things that YOU DO THAT HURTS THE CAR. (ie:exhaust/headers/intake/turbo mostly performance based mods except suspension work does it as well) i dotn see how glassing a piece would void warranty, and i sure as hell hope your skilled enuff for your accord project, becuz (i may bite my tongue later) but those cars dont come on the show circuit standings very often/at all. u better be **** good for all that work anyways.