DVC sub, 1 channel per VC?

[simplyxtrippin 10+ year member]

I have a Hifonics zx6400 http://www.sonicelectronix.com/item_366_Hifonics+ZX6400.html

and i would like to connect it to a DVC 4ohm sub.

This is what im planning on doing. This shows the amp already bridged from 4 to 2 channels. I know that i can wire the amp for 2 ohms, but i would like to use all of the power that my amp could put out. Is this diagram ok? possible? dangerous? should i forget about this concept?

Click to read more...

 

[simplyxtrippin 10+ year member]

anybody?

 

[nutxo 10+ year member]

I have a Hifonics zx6400 http://www.sonicelectronix.com/item_366_Hifonics+ZX6400.htmland i would like to connect it to a DVC 4ohm sub.

This is what im planning on doing. This shows the amp already bridged from 4 to 2 channels. I know that i can wire the amp for 2 ohms, but i would like to use all of the power that my amp could put out. Is this diagram ok? possible? dangerous? should i forget about this concept?

This is correct but if ya **** up the gains you toast the VCs

 

[sonic purity 10+ year member]

Yea, make sure to use a dmm to make sure the voltage is the same going to both coils.