Dual 12 ported box for civic hatch!!

[Rawr-DQ 10+ year member]

It looks like you're licking fecal matter off used toilet paper.

Sick dude.

 

[Rawr-DQ 10+ year member]

Wow yeah, you got some shit to fix.

 

[azimuth 5,000+ posts]

not sure why you even glued that in.

 

[Mexar 10+ year member]

The top isn't glued onto the bottom yet... I might make a bunch of measurements and re-cut the sides tomorrow... probably the best plan... Went out and did a bunch of scraping / sanding... starting to look better

 

[Mexar 10+ year member]

Unlike Pioneer~Saturn... I'm VERY lacking on clamps, so literally sitting on my box as I type (Love those laptops!) Waiting for some glue to dry, sub holes cut out, and waiting on the port paint to dry, then it's going in!

Couple joints to silicone, wires to run, then it's on to test fit!!!

Pics in a bit

 

[Twisted_0912 10+ year member]

lol remnds me when i had to use a circular saw, shit sucked. i agree on at least 96 in of port area for a 6 cube box.

 

[Mexar 10+ year member]

Well none of my cuts are more than 1/16th of an inch out, I just didn't take enough time to actually design and lay out each piece, so a couple spots (Sides / back) got built on the fly. I did take the time to re-do the sides, got the port in, front wall is a bit miffed up.

It fit like a glove in the car... but took a trick or two to get it in, and a stubby screwdriver to mount the subs, so no one just gonna pop the back and walk away with it =P

This week... all week, I'm gonna take my time, using this box as a template, and re-build it a LOT stronger, add some more internal braces, and do a better paint job =P