Does somebody on here like Moe Lester design boxes for a fee?

[Camineet 10+ year member]

I'd love to use a box like the ones in the sticky by Moe Lester, but the ports on all of them are firing forward. I need a box where the port is on the bottom. Can anyone use some software to design a box for me for a fee? Thanks.

Click to read more...

 

[iamamp3pimp 5,000+ posts]

sure.

ygpm

 

[Camineet 10+ year member]

Ok! How much? How do we proceed?

 

[Camineet 10+ year member]

Please refer to the thread:

http://www.caraudio.com/forum/showthread.php?t=211726

to get an idea of what the heck I'm looking for. I'm basically looking for three boxes to tack onto the back side of the wall. Woofers facing front, and the vent firing into the floor. That is - if this isn't half-baked. Thanks.

 

[neonrt 10+ year member]

why dont you just use the same port dimensions as moe lesters, but run the port where you want it instead?

 

[Camineet 10+ year member]

I'd like to do this, but I'd really like to pay someone to actually provide me with a drawing of it. I'm a little bit older, and I have to do a cost benefit ratio on every move I make because of much I've come to equate time with money (I'm an MBA). So if someone can spend 35 minutes or whatever putting together a drawing with the frequency to which I want to tune, and the space and shape constraints that I provide, and only charge me for an hour at their usual rate, then I would probably be better off than trying to draw this up on my own. Plus, when I go to get the wood and get my professional kitchen cabinet building buddy to actually help me put the box together at his shop, it would really help to have that drawing.

 

[jmanpc 5,000+ posts]

Which one are you looking at? I could do it no problem

 

[PV Audio 5,000+ posts]

Professional kitchen cabinet builder, mind you. Not just the ordinary cabinet builders will suffice. //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[Camineet 10+ year member]

Right, I guess that was redundant eh PV? heh.

Ok Jman, great. Well, I really don't know which one to choose. Did you read the thread about where I'm putting these boxes? Please check it out if you have a moment. I also need some guidance on where to tune. I want SQ, not SPL. I understand that this is generally a low tune, but I don't know where exactly to tune. I don't want to be into the extreme end of the SQ/low spectrum such that I don't get a decent rocking box. So where should I be? 28 or 30hz or something? I need to also provide the measurements of the constraints under which I'm operating. In order to do that, I need to take care of a few things that will hopefully be completed over the course of the coming week. Namely, my front seats need to go back in and I need to take some measurements. Now that I think about it, it may be a while before I can actually provide the size constraints I will encounter. For the time being, if you wouldn't mind reading about the wall in the wall thread, that'd be great. Thanks.

 

[expo5.0 10+ year member]

is there bidding here or what?

i can do this later if you want

 

[Camineet 10+ year member]

Well, I guess I'll submit a request for quote when I'm ready to pull the trigger on this. Thanks for all the help on this guys. I'll be in touch.