Disappointed.... at my new substage *AQ 15"s*

[dman4486 5,000+ posts]

daisy chain does not = strapping

 

[WOT]

Ya guys strapping them is when you connect the bridgelink wire and then I have a monster subs 2000rms @ 2ohm lol, thats not connected.

Maybe my one amp isnt turning on or getting power, that would cuase this problem though?

So if I just use the single sub going to the amp I KNOW is working perfect and give it its own RCA source from thh headunit, it WONT HURT the sub that will no longer be connected?

**** this sucks. I built my whole install around both amps working minty

 

[dman4486 5,000+ posts]

if you have a common chamber box, then both subs need power

edit: go back and read my posts...

 

[BobbyDD 10+ year member]

Ya guys strapping them is when you connect the bridgelink wire and then I have a monster subs 2000rms @ 2ohm lol, thats not connected.
Maybe my one amp isnt turning on or getting power, that would cuase this problem though?

So if I just use the single sub going to the amp I KNOW is working perfect and give it its own RCA source from thh headunit, it WONT HURT the sub that will no longer be connected?

**** this sucks. I built my whole install around both amps working minty

No, it won't hurt it. It just won't sound very good.

 

[snb778 5,000+ posts]

doesnt he just need a 0gauge>2x0 gauge splitter so he can hook up the other amp?

or run another power wire

 

[dman4486 5,000+ posts]

doesnt he just need a 0gauge>2x0 gauge splitter so he can hook up the other amp?

if i understand correctly, he needs an rca splitter

 

[BobbyDD 10+ year member]

..

 

[WOT]

Here I'll break down the wiring

The power wire is a 0 gauge all the way back to my box, distro block mounted on the box, 4 gauge seperate power to both amps, both have 4 gauge 16" grounds

RCAS are a single set run from the deck, into one amps INPUT rca chanel, and I have RCAS going from that amps OUTPUT rca chanel to the other amp INPUT rca's. I do have splitters laying around from another install if that would be better than doing it this way, i figured the signal wouldnt lose voltage this way.

And yes, each amp has its own remote, from the deck. and they both have power cause I switched them around.

And yes its a common chamber box

 

[yunvme666 10+ year member]

this is amusing......lol....

 

[WOT]

Whats amuisig about it? Im rather frustrated about it lol

 

[yunvme666 10+ year member]

no i just like the many opinions of what wrong with it thats all nothin against you , i hope you figure out the prob.....lol....

all im gettin to is its hard to say w/o seeing it..

 

[WOT]

Such a process to get my amps unmounted and get the beauty panels off and get access to the wiring even, I should have tested it out before buttoning everything up and hiding wires..... F U C K

 

[snb778 5,000+ posts]

so what did you end up doin?

 

[skateboardkid 10+ year member]

try running one amp at 1 ohm to both subs and see if that works....?

what has happened wit this?

 

[dman4486 5,000+ posts]

curious as well