DB Drive A3 1000.1D

  • 1
    Participant count
  • Participant list

Reddish Neck
10+ year member

TD's & Beer
I found one of these for just over 100$ and was wondering if they are any good.

DRIVESINK heat management system

Buffered pre-amp input circuitry

Continuously Variable 12dB Low Pass X-over

Continuously Variable 12dB Bass boost @ 45Hz

Continuously Variable Subsonic Filter (15-55Hz) (Mono Amps)

Direct-connect integrated Speaker and Power wire Terminals

Full Range RCA Line Outputs for easy Daisy chain

RCA configuration

Variable Input Level Control

DC-DC PWM power supply

DC Short Circuit Protection

Bass Remote capability

4 Ω @ 14.4 VOLTS: 1 x 250 Watts

2 Ω @ 14.4 VOLTS: 1 x 500 Watts

1 Ω @ 14.4 VOLTS: 1 x 1000 Watts

SUBSONIC FILTER: 15-55Hz

CAPABILITY: 1 Ω Mono

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I didn’t want to mess with my daughters EV, so I just made a small stand alone with 6x9s. It’s around 75 watts rms and fairly loud actually. Real...
8
964
You can wire those subs up @8 ohms if they are both SVC4 ohm subs,and that amp will run fine after being tuned properly...
4
1K

About this thread

Reddish Neck

10+ year member
TD's & Beer
Thread starter
Reddish Neck
Joined
Location
Racine, WI
Start date
Participants
Who Replied
Replies
0
Views
5,641
Last reply date
Last reply from
Reddish Neck
1714321195129.png

Doxquzme

    Apr 28, 2024
  • 0
  • 0
1714321134050.png

Doxquzme

    Apr 28, 2024
  • 0
  • 0

Latest topics

Top