Crunk Times, My friend.....Crunk Times

[Tiger Bass 5,000+ posts]

I still need a thread with pictures. I don't know what little plugs to use for the prongs.

 

[iceteebone 5,000+ posts]

I still need a thread with pictures. I don't know what little plugs to use for the prongs.

What the devil do you mean?

 

[iagrdshaka 5,000+ posts]

http://forum.realmofexcursion.com/showpost.php?p=389549&postcount=22

speaking of galatimonkey, people are commenting on his old setup here

http://www.caraudio.com/forum/showthread.php?p=3550703#post3550703

 

[iceteebone 5,000+ posts]

speaking of galatimonkey, people are commenting on his old setup herehttp://www.caraudio.com/forum/showthread.php?p=3550703#post3550703

If I become mod I'll ban him and tell him I'm intoxicated //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

I see he is a mod on roe. I'm going to go raise hell over there.

 

[iceteebone 5,000+ posts]

I didn't read that thread, where did he **** it up?

 

[DBfan187 5,000+ posts]

my balls are squeaky clean now. I just took a shower.

 

[iceteebone 5,000+ posts]

Family Guy was excellent as always.

 

[iagrdshaka 5,000+ posts]

rerun?

 

[iceteebone 5,000+ posts]

yes

 

[Tiger Bass 5,000+ posts]

Your amp needs to be ~ 13V min. if car is on.
Watch it to see if there is voltage drop on the high notes.

Low voltage can cause problems

And I just stick the leads to the power and ground of the amp to test this?

Would I possibly need to check the current too?

And how do I check the resistance of the subwoofer?

 

[iceteebone 5,000+ posts]

And I just stick the leads to the power and ground of the amp to test this?
Would I possibly need to check the current too?

And how do I check the resistance of the subwoofer?

Checking the positive and negative is checking the current //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

Most amps if they drop below 12 volts go into protect.

 

[iceteebone 5,000+ posts]

Not 12V....I'd say closer to 10-11.
Although I have seen some IA 20.1s play off 7V

That's why I said below //content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

 

[Tiger Bass 5,000+ posts]

Checking the positive and negative is checking the current //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif
Most amps if they drop below 12 volts go into protect.

So what's the difference between measuring the voltage and current?

 

[iceteebone 5,000+ posts]

I don't want him to see 11.5 and go OMGWTFBBQ

If he is getting 11.5 with the engine on he should be concerned.

 

[Tiger Bass 5,000+ posts]

Hypothetically, if I am getting 11ish with my engine on, what does this mean?