When installing an epicenter like the Soundstream BX-10X , is it required to have the control Knob installed or can you still use the epicenter without installing the knob. I read somewhere that without the knob installed, the epicenter goes into a kind of bypass mode. Is this accurate? Any info greatly appreciated!!
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
I used a 50k pot. A solder type potentiometer that I soldered panel mount RCA connectors to.
- Started by SlugButter
- Car Audio Build Logs
I own a 2016 Lincoln MKT. I purchased a FORScan chip to increase the power handling of my aftermarket speakers. However, I'm having trouble...
- Started by tripqz
- Wiring, Electrical & Installation
I would put the full range to ch.3&4, and low pass on ch.5&6.
The 6.1200 line out should be full range unless it has a dedicated x-over. In that...
- Started by Tim Schroeder
- Amplifiers
This is in a 2015 F150 regular stereo and I'm using the front speakers for a signal. The EQX is hooked up speaker level. I put a cheezy line...
- Started by Tim Schroeder
- Amplifiers
I assume the plugs are if you have factory equipment like a amp, etc.
- Started by TexanSound
- Head Units
About this thread
Latest topics
-
-
-
Does rear speakers improves driver audio experience?
- Started by MicraMan
- Replies: 28
-
-