Cheapo 2 channel

mtx thunder 250 (1997)

Output power at 12.5V:

2 x 25W @ 4 ohms (

2 x 50W @ 2 ohms (

1 x 100W @ 4 ohms bridged (

1 x 200w @ 4 ohms bridged 14.4 vdc

S/N Ratio: >110dBA

Damping Factor: >200

Fuse: 25A

made in the USA

left and rt. gain control

variable HP/LP filter (50-200hz)

0 to +18db @ 40hz boost

hi- and lo- level inputs

PM me an offer

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
145
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
375
Pretty much. It's just a nice kit. A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
10
756
Slapz are sfb clones from my understanding. What I was pointing out is how much info slapz gives about their amps 😂
35
2K
Thanks for that. Good point about the chimes, I 'll have to check. My thoughts were that a true center channel could serve to raise the sound...
3
443

About this thread

jrdnhsnbrg

10+ year member
Pimped my grandma's ride
Thread starter
jrdnhsnbrg
Joined
Location
Eau Claire, WI
Start date
Participants
Who Replied
Replies
13
Views
840
Last reply date
Last reply from
jrbsr05pt
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top