Channel Distribution Question

  • 2
    Participant count
  • Participant list

erutter11

Junior Member
Hi,

Alpine iDA-X303 4 channel head-unit (16 watt RMS, 45 peak)

Rockford Fosgate R1653 6.5 (80 RMS, 160 peak)

Kenwood KFC-6982ie 6x9 (80 RMS, 450 peak)

I'm buying Sound Storm SSL F2.600 Amp for my 6x9s and a Clarion EQS746

7-Band Equalizer.

I'm wondering if when I run the SSL amp to the 6x9s, can I run 2 channels from my deck to each 6.5 or is that impossible?

Thanks.

 
two channels for 69's two for 65's

simple.

assuming the HU will be okay with using rca and line out at the same time...which it likely will.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
178
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
400
Pretty much. It's just a nice kit. A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
10
795
Slapz are sfb clones from my understanding. What I was pointing out is how much info slapz gives about their amps 😂
35
2K
Thanks for that. Good point about the chimes, I 'll have to check. My thoughts were that a true center channel could serve to raise the sound...
3
452

About this thread

erutter11

Junior Member
Thread starter
erutter11
Joined
Location
grayling
Start date
Participants
Who Replied
Replies
1
Views
331
Last reply date
Last reply from
shaneb
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0

New threads

Top