Changing fuseholder

[negativezeroz 5,000+ posts]

My EPX fuseholder is about to give out..lol...battery leaked on it and got inside..

well got a new Stinger HPM SFB1MAXPT fuseholder....whats the best way to get the powerwire out of the EPX and into the Stinger? and do I need to get any like clips or anything to connect the PW to the Stinger fuseholder?

thanks

new fuseholder

Click to read more...

 

[jtomsic 5,000+ posts]

unscrew the bolts holding the wire down, slide it in the new holder tighten them down.. pop ur fuse in.

 

[negativezeroz 5,000+ posts]

o ok lol im making it harder than it should be //content.invisioncic.com/y282845/emoticons/blush.gif.99bc659ee2012b7d826165e26fb5eebe.gif ..but unhook - on batt first then + (to be safe) then do that lik 2min swap..

 

[MustangGT25YRS 10+ year member]

Hi Neg,

I would also look at the cable stranding(Which I'm sure you will) and see if the stranding is corroded also.If you have enough "Slack" in the cable,I would cut off that part of the cable and use a "fresh piece" of the cable into the New Fuseholder....just to be safe,with full potential of the cable.Hope that helps also. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif .Take Care.

//content.invisioncic.com/y282845/emoticons/wave.gif.002382ce7d7c19757ab945cc69819de1.gif