Hey everybody I recently closed done my car audio business and have my display for sale. The display is very large and in very good condition. The center section houses all the circuit boards and the MTI control panel. Up the 24 radios and 8 seperate amplifers (amplifier configurations are F/R and F/R/S. To both sides of center are 3 pillars with 8 speaker locations in each. All three pillars are wired into the soundboard as a L/R set, giving a end result of 24 pairs of front stage speakers. On the right side of the display is a walkthrough opening and then an additional pillar with 8 speakers. On the left side is another opening the same size as the walkthrough except, the left side has 4 more subwoofer amplifier boards and 4 dedicated subwoofer terminals. Again like the right side an additional pillar with 8 speaker locations. The two rear pillars are wired to the soundboard in a rear L/R set. The entire display seperates into individual pieces but can only be assembled one way, when complete makes about 2/3 of a complete circle. All the wiring is simple plug and play and the whole unit can be completly assembled and working in a couple hours. All of the pillars, walls and center unit are covered in a light tan formica while the connecting bases and tops are covered in dark blue formica. All of the speaker and amplifier plates are covered in grey formica, and use machine screws with nutzerts for easy removal and installation. I am asking $8000.00 and buyer is responsible for shipping. Although I will travel to buyers location to assist with assembly and instruction on how to use if so desired. Thank You for your time
