can a viper d2500.1 be run lower than 1 ohm?

[IgnoreMe 5,000+ posts]

the orion and viper are supposedly the same amp almost just rebadged and i know the orion can be run really low. my question is can the viper be ran any lower than 1 ohm? i dont believe so but its worth a shot...anyone heard/do this before?

Click to read more...

 

[bonesninja 5,000+ posts]

well since its 2 ohm stable ----i doubt it.

 

[PhatTonyDeMarco 5,000+ posts]

well since its 2 ohm stable ----i doubt it.

//content.invisioncic.com/y282845/emoticons/eyebrow.gif.fe2c18d8720fe8c7eaed347b21ea05a5.gif The 2500.1 does 2500w x 1 @ 1 ohm...

I have heard of people doing it, but without success. Protect mode city... But for burps they are known to do pretty good under 1 ohm.

What load are you trying to run it at?

 

[SBLAZER]

i thought the viper was 2500x1@2ohm, it can be run at 1ohm daily i dont kno about anything lower than that. u may can try it for a burp, but i doubt u will actuualy see that ohm load anyway, becuz od impedence rise and stuff like that,.

 

[Randy Savage 5,000+ posts]

Viper and Orion 2500D are different amps...

 

[Shyne151 10+ year member]

//content.invisioncic.com/y282845/emoticons/eyebrow.gif.fe2c18d8720fe8c7eaed347b21ea05a5.gif The 2500.1 does 2500w x 1 @ 1 ohm...
I have heard of people doing it, but without success. Protect mode city... But for burps they are known to do pretty good under 1 ohm.

What load are you trying to run it at?

What are you talking about? it's 2500@2ohm.

 

[btnhfan 5,000+ posts]

Im pretty sure its 2500w at 2 ohms

It doesnt like 1 ohm daily.

Theres a post on it over at termpro.

 

[PhatTonyDeMarco 5,000+ posts]

Hmm.. I could have sworn it was 2500 at 1 ohm. My bad //content.invisioncic.com/y282845/emoticons/blush.gif.99bc659ee2012b7d826165e26fb5eebe.gif

I am thinking of the 1200.1 then...

In that case, if it doesnt even have a rated power under 2 ohms, I doubt its a good idea to run it under 1 ohm daily.

 

[IgnoreMe 5,000+ posts]

so no way is it running .5 ohm load?

 

[PhatTonyDeMarco 5,000+ posts]

so no way is it running .5 ohm load?

What is the coil config for the sub(s) you are running?