Can A 2 Channel Amp Be Used To Run Components And Rear Fill Speakers?

[bones justice 10+ year member]

i have a pair of beyma midbass speakers in the backdash

(6.5" 4ohms 100 watts rms.)

also a pair of beyma components in the front doors

(6.5" 4ohms 80 watts rms)

i already have a 2 channel amp from before. a MTX Thunder TC 4002. rating is:

100x2 @ 4ohms

200x2 @ 2ohms

400x1 @ 4ohms bridged

since all the speakers are 4ohms i was thinking i cod wire the left door components and the beyma midbass speaker on the left side in the backdash to 2ohm stereo so they can play together. also the same to the right side components and the right beyma speaker in the backdash.

can a component and a rearfill speaker be hooked up to the same channel. would it make a difference?

Click to read more...

 

[djeazie 10+ year member]

You can do that but you wouldnt be able to fade.

 

[bones justice 10+ year member]

what u mean fade?

 

[blimblam 10+ year member]

like instead of having music played through both rear and the front, you can face it to the front only so you can have better sound quality.

 

[buildmeabox 10+ year member]

Yes you can wire your front and rear speakers but if your not using some sort of kick panel setupfo the front then wire the passenger speaker out of phase.