Building an enclosure for JL 18W3

  • 2
    Participant count
  • Participant list
Hi this is my first post here, and i'm going to be building an enclosure for my 18w3 soon.

I'm looking for advice on the best specs i should build it to. So far, i'm planning on building it around 5 ft^3 and tuning it to around 25-32hz. I'm just about sure this would work just fine, but im looking for an enclosure that allows the sub to perform its best and get as loud as possible. Thanks for any advice.

 
I would keep the tuning a little higher around 32-35ish. I tried tunning a few of the W3s lower and i was very unhappy with their performance.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Build currently on hold, waiting on a custom voice coil. The former isnt tall enough for the new setup. On the plus side the motor has 3.25" of...
30
4K
Damn thats a lot of power. You built that whole thing with no BMS? A balancer is good to add of course but a bms is mandatory. I see people doing...
26
6K

About this thread

humandrummachin

Junior Member
Thread starter
humandrummachin
Joined
Location
Minneapolis, MN
Start date
Participants
Who Replied
Replies
4
Views
1,148
Last reply date
Last reply from
pro-rabbit
1000007975.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0
1000007974.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0

New threads

Top