Heres my current setup:
Factory HU with 4 channels out --> SVEN4 --> front channels directly to
300/4 front inputs --> front comps
rear channels go to 500/1 then pass thu to 300/4 rear inputs --> rear comps
I am going to bridge the 300/4 to 2 channels for the front comps and ditch the rears. What is the best way to wire the 4 channels of output to both amps? I would like to be able to retain fade (comps to sub) and balance control from the hu.
Would there be any benefit or reason you would split the hu front/rear outputs and run front left and rear left to the front inputs on the amp and run front right and rear right to the rear inputs on the 300/4?
