Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Bridging an amp and inputs
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="dadood" data-source="post: 5128626" data-attributes="member: 603172"><p>Heres my current setup:</p><p></p><p>Factory HU with 4 channels out --&gt; SVEN4 --&gt; front channels directly to</p><p></p><p>300/4 front inputs --&gt; front comps</p><p></p><p>rear channels go to 500/1 then pass thu to 300/4 rear inputs --&gt; rear comps</p><p></p><p>I am going to bridge the 300/4 to 2 channels for the front comps and ditch the rears. What is the best way to wire the 4 channels of output to both amps? I would like to be able to retain fade (comps to sub) and balance control from the hu.</p><p></p><p>Would there be any benefit or reason you would split the hu front/rear outputs and run front left and rear left to the front inputs on the amp and run front right and rear right to the rear inputs on the 300/4?</p></blockquote><p></p>
[QUOTE="dadood, post: 5128626, member: 603172"] Heres my current setup: Factory HU with 4 channels out --> SVEN4 --> front channels directly to 300/4 front inputs --> front comps rear channels go to 500/1 then pass thu to 300/4 rear inputs --> rear comps I am going to bridge the 300/4 to 2 channels for the front comps and ditch the rears. What is the best way to wire the 4 channels of output to both amps? I would like to be able to retain fade (comps to sub) and balance control from the hu. Would there be any benefit or reason you would split the hu front/rear outputs and run front left and rear left to the front inputs on the amp and run front right and rear right to the rear inputs on the 300/4? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Bridging an amp and inputs
Top
Menu
What's new
Forum list
