bridging 2 AP3000D amps problems

[jeep_poundin 10+ year member]

ive wired the amps up like the manual shows and neither are turning on. they each have the right power and negative supply. remote works. and each have a 250amp fuse. any reasons why they arent turning on??

Click to read more...

 

[power-fanatic07 5,000+ posts]

Did you by chance hook the + to the - side?

 

[jeep_poundin 10+ year member]

no. i checked that too

 

[jeep_poundin 10+ year member]

bump

 

[I Like Waffle]

i dont think the AP3000s are bridgable bro, only the smaller amps like 1500 and 1800. The 3000s is already 2 amps bridged.

 

[jeep_poundin 10+ year member]

the manual that came with it shows they are. even the company i bought it from said they are

 

[I Like Waffle]

weird, what ohm load are they bridgeable to?

 

[jeep_poundin 10+ year member]

here's the link to the amps PLANET AUDIO | YOUR FINAL DESTINATION

 

[jeep_poundin 10+ year member]

2 ohm. my subs arent installed yet. but they will be running at 2.67 ohms

 

[Beatdown337 10+ year member]

ohhhhhhh youre talking about planet audio. I thought you were talking about audiopipe lol. Are the speakers just not playing? Or is the amp just not turning on?

 

[jeep_poundin 10+ year member]

oh my bad. the amps just arent turning on

 

[Beatdown337 10+ year member]

did you run power, ground, and remote wires to them individually. If so they should at the least be turning on

 

[ltr450racer690 10+ year member]

have a remote to both?

 

[jeep_poundin 10+ year member]

coming from the positive terminal i have a distribution block with 2 250amp fuses then the 2 positives run to the amps. remotes are split one going to each. and for the negatives, i ran those back too the batteries

 

[Beatdown337 10+ year member]

i would check the remotes and fuses