Box for Firebird / camaro Cubby

[Stros 10+ year member]

Anyone know or have any pics of boxes made for the Firebird / camaro cubby in the trunk around years 93+. Dimensions would be even cooler.

Thanks in advanced.

Click to read more...

 

[jellyfish420 10+ year member]

ya i got some dimentions, let me look....

fiberglass!!!//content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 

[Stros 10+ year member]

anyone else?

 

[analogkid]

are you talking about the box that fills the entire back well or the enclosures that tuck into the sides of the well leaving the t-top slots free?

 

[Stros 10+ year member]

The t top storage one, even though i don't have t tops, i only have 1 10" so theres really no point in me taking up a lot of space in the trunk.

 

[Jesse98 10+ year member]

im doing a full install on a 94 z28 click link at bottom of pg5 of http://www.sounddomain.com/id/7111985 I have pics of so far progress havnt started the glassing yet but I will and will post progress pics, check it out.

 

[analogkid]

just get a 10" thunderform. it tucks into the driver side of the back well. i put 1 into my friends 95 z28 with a 10" mtx 6000. it worked very well.

 

[Stros 10+ year member]

I don't really want to buy one of those pre made plastic ones,

Jesse98, what kinda sub are u putting in the box? and is it possible u could glass a 2nd and sell it?

 

[traksta15 10+ year member]

do a search on ebay for "camaros" in the enclosure section, some of them give u dimensions and what not, thought about buildin 1 for mine (90), but there's not enough airspace in the dip part......

 

[FSUNole17 10+ year member]

hey i have a custom made to spec, ported box for a 12W7 that takes up the entire ttop storage area, check in the for sale section if u are interested... i really need to get rid of it and this setup POUNDS

 

[Jesse98 10+ year member]

I don't really want to buy one of those pre made plastic ones,

Jesse98, what kinda sub are u putting in the box? and is it possible u could glass a 2nd and sell it?

Im putting 2 Diamond Audio CM3 12"s in it, yea I can make one but differ than the one I am making (unless you want something similar) but I plan to glass the entire hatch area of the camaro its gonna have the two subs at the corner of the rear of the hatch kinda angled at a 45 and going to flush mount the amp between them and were doing a raised chevy bow tie over the flat part that over the rear end going to be nice but lots of work and not cheap.

 

[Stros 10+ year member]

oh, im not looking for the bottom part, just the part for the little cubby on the drivers side, i think im going to attempt to make one out of MDF