Box Builders Enter - Double Check And Cut Sheet

[Johnny Law.Lulz 5,000+ posts]

But you only have 6.87ft^3 after ports, so that is what you put into the calc. It's an ass-backwards way of doing it, but it has to be done that way. It's a lot easier to do with a slot port, because you can make the port however wide to increase or decrease the port length in order to achieve a predetermined volume that you set aside for the port(that's how I do it anyways).

So what is i add that 1.25 to my 8.12 and then put that in the calc so i have 8.12 after port displacement. Is that what i need to do to make sure i have 8.12 tuned to 36 with the length i already have. 7 cubes aint gonna cut it so i need that 8.12

 

[Johnny Law.Lulz 5,000+ posts]

New measurements give me 9.45, so minus sub and port displacement this gives me 7.95.

7.95 with 2 8" aeros to get 36hz gives me 21.4" per flared port.

Edit: New meausrements are

62" Wide

24" Tall

13.5" Deep.

 

[RAM_Designs 5,000+ posts]

New measurements give me 9.45, so minus sub and port displacement this gives me 7.95.
7.95 with 2 8" aeros to get 36hz gives me 21.4" per flared port.

Edit: New meausrements are

62" Wide

24" Tall

13.5" Deep.

Looks good...what is this for?

 

[Johnny Law.Lulz 5,000+ posts]

Looks good...what is this for?

21" Warden in an Extended cab F150 on an RD D9

 

[mbrooky 10+ year member]

New measurements give me 9.45, so minus sub and port displacement this gives me 7.95.
7.95 with 2 8" aeros to get 36hz gives me 21.4" per flared port.

Edit: New meausrements are

62" Wide

24" Tall

13.5" Deep.

looks good...now build it! //content.invisioncic.com/y282845/emoticons/tongue.gif.6130eb82179565f6db8d26d6001dcd24.gif//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif