box build for 2 dd 510b.

[memphis_vette 10+ year member]

1st box build i have done by myself...it turned out decent.

here is the dd 510b subs i am using...box is 2.9 cube tuned to 33hz. 2 ports and a center divider to seperate the subs. almost done just need to sand and do wiring.

Click to read more...

 

[memphis_vette 10+ year member]

in the last 2 pics the top board is not screwed down it was just set on top. this build is for my girls car. should sound good and get pretty loud

 

[I Like Waffle]

Little uneven brotato, looks good though. Next time use a table saw or get a track for your circular saw. Looks like you did the cuts with a jigsaw. You gonna wrap it with anything

 

[memphis_vette 10+ year member]

yea i used a jigsaw. yup im going to get some black carpet and then paint the ports pink

 

[memphis_vette 10+ year member]

subs are slappin. sounds good and gets loud off of a zapco refrence 500. cant wait for my AQ 1200d to get here 2mro and really see what these lil 10's can do

 

[MONSONwarrior Premium Member]

Why didn't your 45 corners and round off the port?

I tried to build a box with only a jig saw, bad idea. Now I use a circular saw and it's still a little difficult to cut perfectly straight, just gotta sand a lot.

 

[memphis_vette 10+ year member]

i just didnt feel like getting that into as it is just some slap for my girl. yea jig saw ***** it was pretty hard

 

[budahbuddy803 10+ year member]

Jig saw or circular saw if you use a clamped straight edge to help line up the cuts its pretty hard to not cut straight. Measuring correctly is a whole nother story for me haha

 

[evanirr 10+ year member]

Holy caulk lol

 

[memphis_vette 10+ year member]

lol yee

 

[evanirr 10+ year member]

you should just build a baffle to go over the front, to seal up that gap and flush mount the woofers : )

 

[memphis_vette 10+ year member]

thats a good idea

 

[MONSONwarrior Premium Member]

you should just build a baffle to go over the front, to seal up that gap and flush mount the woofers : )

also rather difficult with a jig saw //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif

 

[memphis_vette 10+ year member]

true lol