Birth sheet for RFP 360.2
- Thread starter Tryin2bump
- Start date
- Replies 1
- Views 1K
tryin2bump- goto rockfordfosgate.com
web page. click on RF-TECH click on
archived amplifiers you will need adobe
read program to down load specification.
if you need just power information
power 360.2
90x2 into 4ohms
180x2 into 2ohms
360x1 into 4ohms (bridge/mono)
web page. click on RF-TECH click on
archived amplifiers you will need adobe
read program to down load specification.
if you need just power information
power 360.2
90x2 into 4ohms
180x2 into 2ohms
360x1 into 4ohms (bridge/mono)
Activity
No one is currently typing a reply...
Similar threads
Yeah I had torn one down and used my digital calipers to measure coil size ID & OD and winding height and spiders all had it written down and had...
- Started by BigMan813
- General Car Audio
Here is a chart that gives you relative cone size.
Diameter of speaker*|*Cone area of speaker in square inches
18"*--->*254
15"*--->*192...
just use riv-nuts or clip-nuts, made for blind fastening. some window weld should hold the ring on there pretty good..... being 4x6, you could...
- Started by HardofWhoring
- Enclosure Design & Construction
About this thread
New threads
-
-
Head unit 1 output rcas, to 5 channel amp, LOC or 1 set off HU
- Started by RyanJ0022
- Replies: 6
-
-
-